Page 3 of 4 FirstFirst 1234 LastLast
Results 21 to 30 of 36
Like Tree6Likes

Thread: Honing Critique, Please...

  1. #21
    Norton convert Blix's Avatar
    Join Date
    Jun 2011
    Location
    Stabekk, Norway
    Posts
    1,380
    Thanked: 310

    Default

    Personally I guide the razor with both hands as well, however I place my thumb behind the spine to push the razor, rather than holding it down with a finger on top.I do rest my pinky and middle finger on top, but with no pressure. That is fine for me up til the last few finishing strokes, then it's one hand going as light as possible.
    Using a couple smaller cotis I'm fine with hand holding the stone as well. But on the larger stones I do whatever feels right.

  2. #22
    Customized Birnando's Avatar
    Join Date
    Feb 2010
    Location
    Oslo, Norway
    Posts
    5,079
    Thanked: 1694

    Default

    I tend to use both hands on a hone that is set on the table, especially on the lower grits.
    I prefer a one hand approach when holding the hone in my hand and for the higher grits.

    There are many ways to skin a cat
    Bjoernar
    Um, all of them, any of them that have been in front of me over all these years....


  3. #23
    Member AFDavis11's Avatar
    Join Date
    May 2005
    Location
    Virginia
    Posts
    5,726
    Thanked: 1486

    Default

    Yes, at the end of the honing cycle any pressure is too much. Lots of people hone with two hands though and seem to get good results. I'm only advocating for exceptional results.

  4. #24
    Member AFDavis11's Avatar
    Join Date
    May 2005
    Location
    Virginia
    Posts
    5,726
    Thanked: 1486

    Default

    Quote Originally Posted by Birnando View Post

    There are many ways to skin a cat
    But, still, one best method to herd them!

  5. #25
    what Dad calls me nun2sharp's Avatar
    Join Date
    Feb 2008
    Location
    Kansas city area USA
    Posts
    9,172
    Thanked: 1677

    Default

    Nothing wrong with the two handed approach as long as the finger on the blade is simply keeping the blade flat. As has been said previously the hone goes in the hand for the finishing touches, this means no finger on the blade at all.

    BTW Not only is Randydance a great mentor, his avatar is as well, I used to sit and watch it constantly a few years back, what a great learning tool!
    Last edited by nun2sharp; 09-26-2011 at 11:04 PM.
    It is easier to fool people than to convince them they have been fooled. Twain

  6. #26
    Plausibly implausible carlmaloschneider's Avatar
    Join Date
    May 2011
    Location
    Mount Torrens, South Australia
    Posts
    5,979
    Thanked: 485

    Default

    Firstly, I'd like to say that the last bunch of posts on the finger have been really helpful, I really appreciate those comments. I do now understand how important that point is. When Blix spoke of the finishing strokes and the thumb, etc, it all finally came together. I think maybe I HAVE been using a little too much pressure, and get how removing the finger might ensure almost no pressure is used. I'm going to try that tonight on the W&B, which (I almost typed 'who' then, I think I have issues) wasn't up to the par of the first two I refreshed on the W/E. I'm worried that by using one hand the blade will rock from side to side on the hone; and I'll end up honing on the edge of the hone; not the top surface. I may also try the thumb idea, rather than the finger on top.

    Also, I agree with the comment about Randydance's avatar, I think that's called subliminal learning
    Stranger, if you passing meet me and desire to speak to me, why should you not speak to me? And why should I not speak to you?
    Walt Whitman

  7. #27
    The Great & Powerful Oz onimaru55's Avatar
    Join Date
    May 2008
    Location
    Bodalla, NSW
    Posts
    15,623
    Thanked: 3749

    Default

    Quote Originally Posted by carlmaloschneider View Post
    I'm worried that by using one hand the blade will rock from side to side on the hone; and I'll end up honing on the edge of the hone; not the top surface.
    Or you might not worry about it & just call it the rolling X stroke.
    You can actually hone quite close to the edge without running over it but it will take some practice...
    Maxi likes this.
    The white gleam of swords, not the black ink of books, clears doubts and uncertainties and bleak outlooks.

  8. #28
    Member AFDavis11's Avatar
    Join Date
    May 2005
    Location
    Virginia
    Posts
    5,726
    Thanked: 1486

    Default

    Honing with one hand is not something you will do correctly just because you understand it. It requires practice. It's more like painting than crochet.

    Do NOT make any conclusions on it's value until you've tried it for a while, perhaps 4-6 years. :-)

  9. #29
    ..mama I know we broke the rules... Maxi's Avatar
    Join Date
    Feb 2010
    Location
    Toronto, Ontario, Canada
    Posts
    2,895
    Thanked: 993
    Blog Entries
    8

    Default

    Quote Originally Posted by AFDavis11 View Post
    Honing with one hand is not something you will do correctly just because you understand it. It requires practice. It's more like painting than crochet.

    Do NOT make any conclusions on it's value until you've tried it for a while, perhaps 4-6 years. :-)
    I totally agree. When I began honing, the one handed approach was painstaking. The razor was going everywhere, this way and that....and that was with an X stroke. OMG, nevermind circles! Ha...it was brutal. Anyone who would have watched may have burried their head in their hands and cried. Two hands solved the steadiness problem, and I taught myself to use a feather light touch with my supporting hand. Then, I ran into some old junkers, and a couple of mine needed to be rehoned at the same time. I sat down and practiced one handed, over and over and over. X's, circles, you name it. Now I more comfortable with one hand than two, BUT....it really just increases the bag of tricks. Flipping accurately on a hone also required some practice.

    Anyway, that's my two cents. I think it's best to have as many tricks as you can in your honing bag.
    alb1981 likes this.

  10. #30
    Norton convert Blix's Avatar
    Join Date
    Jun 2011
    Location
    Stabekk, Norway
    Posts
    1,380
    Thanked: 310

    Default

    Having a junker to practice on sure helps, last Sunday I spent 3-4 hours over the day playing around with my cotis, both handheld, that's what Gold Dollars are for!

    I feel my 27 years of playing guitar helps a lot too, I have pretty good coordination between my hands.
    And it's all about finding a certain rhythm for all your moves, to make a razor sing.

Page 3 of 4 FirstFirst 1234 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •