Thread: Its a crying shame....was going to be a very nice Dubl Duck Dwarf

Originally Posted by audi90kid

Thanks, but there in lies my problem, I have not seen a lot of blades that are this short, this is a 2.5" blade.

I wonder if that one was shortened or if they made different length models of the Dwarf. Mine was full length, 2.75"

mine may be the same length, i measured the actual cutting surface not the entire length of the blade, where should I be measuring from?

That's fine . I was referring to cutting edge also.

I have a few broken blades and thought I might make some whittling knives from them.
Ricks Hand Made Razor Knives describes his process here.
Making a Carving Knife from Little Shavers

It would be really nice if the logo on shank could be displayed thru a cutout on the handle. But I don't know if there would be enough support.

(just found a post on this topic here in this forum)
http://straightrazorpalace.com/razor...ed-blades.html

well as promised I am keeping updated, got lucky and found this on eBay and the owner said that there was no cracks or nicks. If this is true then I should be up and running, after some serious thought I have a few new ideas I am going to try in the process to make this thing the best it can be. oh and don't worry I am going to be extra careful with the buffing wheel or not use it at all just do it by hand.