Search:
Type: Posts; User: Euclid440; Keyword(s):
Search: Search took 0.06 seconds.
-
10-02-2015, 03:55 AM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
I have seen some, about $1.83 per washer, with a...
I have seen some, about $1.83 per washer, with a 100 unit minimum. Much cheaper to buy a punch & die set and make your own.
-
09-29-2015, 03:46 PM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
Just smash with a hammer, usually the hole does...
Just smash with a hammer, usually the hole does not change, if it does ream with a drill. If you buy a 1/16 in bit with the hex shaft ($3 at Lowe’s), you don’t need a pin vise.
I get them as flat... -
09-29-2015, 01:44 PM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
Peened dome side up, either to fill the hole or...
Peened dome side up, either to fill the hole or domed over smooth.
213795213796 -
09-29-2015, 01:14 PM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
I then take a 4-5 inch piece of bamboo chop stick...
I then take a 4-5 inch piece of bamboo chop stick and dimple the end so it fits over the pin head,( just a bit smaller) of the pinned razor.
Put a dab of .5 Diamond paste, rubbing or polishing... -
09-29-2015, 12:44 PM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
Here’s the polishing mandrel, just a bolt with...
Here’s the polishing mandrel, just a bolt with the head ground down a piece of 1/16 in id brass tubing and nut.
Polish with metal polish and Chrome Oxide.
... -
09-29-2015, 12:38 PM
Thread: Trouble Making Domed/Support Washers
by Euclid440- Replies
- 15
- Views
- 1,619
A tapered diamond burr, from Harbor Freight ($8...
A tapered diamond burr, from Harbor Freight ($8 for the set) in a pin vise will open the hole nicely. Also works well for tapering the hole in the scales to prevent cracking, when pinning.
Here is...
Results 1 to 6 of 6