Results 1 to 10 of 15
Thread: First DIY Strop.
Hybrid View
-
09-21-2014, 10:45 PM #1
Tintin, any recommendations for slicking tight corners and notches? I had no luck getting to where the D-ring and clasp feed through. Is this where an edge dressing would have been better?
-
09-22-2014, 09:52 PM #2
I made this little burnisher that fits in my dremel tool. it's just a screw that i put a piece of wood (walnut in this case) on and turned on my drill press. it's about a half inch at its largest diameter. it really speeds up the burnishing process. you have to be careful not to burn the leather.
i use Gum tragacanth followed by a mixture of bees wax and parafin.
Last edited by tintin; 09-22-2014 at 09:55 PM.
-
The Following User Says Thank You to tintin For This Useful Post:
JustAKnick (09-23-2014)
-
09-23-2014, 01:50 AM #3
Thanks bruseth for the compliment and words of encouragement!
Tintin, Thanks for the assistance. I think I might work on making my own this weekend. That is an awesome idea. I'm sure it will work on my cordless drill just as well (maybe a bit more cumbersome) or maybe I'll dive in on a dremel. The one I picked up is about 1.5 inches in diameter and useless for the tight spots.