Results 1 to 5 of 5
Thread: Source for pins?
Hybrid View
-
02-01-2007, 06:38 AM #1
This topic came up a few times in the restoration forum. Here's the short answer...
Pins -- 1/16" brass rod stock, found in any hobby shop that caters to RC car people (generally any good hobby shop)
Washers -- Inside #0W, outside #0, found at www.microfasteners.com, generally brass.
Using a 0.5lb ballpeen hammer and a small anvil (I got my 11lb for $8.00CDN) help make the job easier.
-
02-01-2007, 06:39 AM #2
By the way this is by no means the only way to pin scales on a razor, but it's the easiest way to start.
-
02-01-2007, 02:41 PM #3
Thank you Ilija - John
-
02-01-2007, 09:32 PM #4
John,
Good luck and enjeux