Sounds like stacked washers. Can you post a pic?
Printable View
http://uploads.tapatalk-cdn.com/2016...5c3493abef.jpg
Pretty hard to get a pic but this is it. When assembled it looked like 1.
Sent from my SM-G930R4 using Tapatalk
Yup, stacked washers..
Whatever you do, and this is vitally important, don't mix them up...
No not really, although there is an inside and outside one if you look closely that fit together to go on either side.
:tu
As seen in the picture, I'd guess the top one is an outside one, the next two are against the scale, and the lowest one is again an outside..
I think really, while re pinning, they would level out no matter what you did..
Could be wrong though so I try to keep the orientation the same as removed.
Not that I've seen so far, maybe the wedge isn't quite right, and there was binding in the tips of the scales when opening, so then it was shimmed open for clearance. Hmmm.
Thanks for the info gents, ill just put them both back when i assemble.
Sent from my SM-G930R4 using Tapatalk