Thread: Looking for small washers?

Jamie the ones I linked are only 1/8 diameter so the peen pretty much covers the washer after you are done, not sure if they get much smaller they will even hold onto the washer

Might be better to go "Washerless" and maybe spin them

Here’s a link to a how to Dome Microfasteners washers, post 5. Doming reduces the OD and come out real close to original factory washers.


You can fill the dimple, when domed it creates a nice, V well to hold the peened head, or peen the head large to almost cover the entire washer.

These are the ones I'm looking for here's a lineup of the 5 different washers I use the one on the end I use when going for that washerless look as a small peened head covers the washer especially effective when used with nickel silver pin, I only have a few left and I'm not sure where I got them from in the first place they seemed to be stainless steel I've taken a photo with measurements.

Originally Posted by celticcrusader

These are the ones I'm looking for here's a lineup of the 5 different washers I use the one on the end I use when going for that washerless look as a small peened head covers the washer especially effective when used with nickel silver pin, I only have a few left and I'm not sure where I got them from in the first place they seemed to be stainless steel I've taken a photo with measurements.

Microfasteners used to carry them for some time, I am not aware of other distributors for that size.

Jamie the ones I linked will be right between the two smallest you posted

at about 3.1mm

This is another source but you have to call them about the tiny ones which for you is a bummer..
Their #0 Med size fits the Nickel Silver rod better though,

http://www.fastener-express.com/

Originally Posted by gssixgun

Jamie the ones I linked will be right between the two smallest you posted

at about 3.1mm

They will be perfect Glen, I followed your link and placed the order.

Originally Posted by gssixgun

Jamie the ones I linked will be right between the two smallest you posted

at about 3.1mm

This is another source but you have to call them about the tiny ones which for you is a bummer..
Their #0 Med size fits the Nickel Silver rod better though,

Fastener Express - Socket Head Cap Screws, Metric Screws , Fasteners and Anodized Aluminum for the Hobby Industry.

Glen the ones you linked arrived perfect thanks again.