Results 1 to 10 of 34
Thread: Rust under the rubber grip
Threaded View
-
05-19-2016, 12:26 PM #21
Since I couldn't find any information on something like this when I searched I will document how I do this so others can find something in the future. If anyone has suggestions or advice along the way feel free to jump in.
First off I cleaned all the rust off with a razor blade then go to grinding off the rest and getting most of the pitting out. This did remove some metal but as I plan to epoxy over the area this gives me room to build it up a bit
Next was to put the grip back on and mark where it sits so I know where I need to prep for the epoxy.
After that I took a pin file and roughed up the area I needed so that the epoxy will have something to really grip to.
That's all I have had time for but will update as I goMy wife calls me......... Can you just use Ed
-
The Following User Says Thank You to eddy79 For This Useful Post:
Substance (05-25-2016)