Results 1 to 10 of 34
Thread: Rust under the rubber grip
Threaded View
-
05-24-2016, 11:53 PM #24
So has cured now so to start the shaping. Re taped the edges to avoid scratches and use a file for bulk removal till had it roughly there. Then used some 600 w and d wrapped around a pop stick to get it fully shaped. The tape helps at the edges as it creates a level slightly above the metal so once removed you are left with a very thin raised edge with a clean line. Did slightly go through the epoxy on a couple corners as it is a quite thin layer so going to touch that up then carefully hand sand. Pics so far.
My wife calls me......... Can you just use Ed
-
The Following User Says Thank You to eddy79 For This Useful Post:
Substance (05-25-2016)