Results 1 to 10 of 13
Thread: Question About Epoxy
Threaded View
-
08-20-2017, 06:12 PM #7
I've only used it with relatively thin layups of epoxy/glass, polyester/glass, and on the epoxy/paper micarta that I make, so heat has not been an issue. I'ts a bit scary the first time you rely on it with a mold that you have a lot of work in, but I've never had any problems. As I said there are waxes made specifically as mold releases. I use 'Part All' because I have it. If I were going to use other waxes in a 'must work' situation, a test prior to use would be prudent.
-
The Following 2 Users Say Thank You to bluesman7 For This Useful Post:
outback (08-20-2017), ScoutHikerDad (08-20-2017)