Results 1 to 10 of 42
Thread: Scales Experiment.
Threaded View
-
07-05-2020, 09:47 PM #8
For a mold, it will never be thin enough to pour. It would have to be injected under high pressure. But it could be "press" molded, with the use of a C-clamp.
Some small vent holes between the two halves of the mold, will allow air and excess plastic to escape, and making the flashing easier to remove.Mike
-
The Following User Says Thank You to outback For This Useful Post:
JBHoren (07-17-2020)