Thread: Restoring a Cheap Antique Shop Razor

Originally Posted by outback

Need better pics of both sides of the blade, in whole. Pics of parts of the razor does me no good.

Need to see the condition and hone wear that the blade is in.

How close do you want them? I can go take some macros right now, just need to know what I'm taking. By default I would just be laying the razor flat and taking a close up photo of the whole blade, with no particular emphasis on the bevel. I could also shine light on the bevel or tilt the razor if necessary.

Like these.

Here you go:

1. Its been honed to death.

A major heel correction is in need. Hone wear is hitting the whole width of stabilizer.

To be blunt, and honest....not worth the effort, or time, to make usable.

Toss it, there's so many more better blades out there. Especially to try and learn to hone something like this, let alone, restore.

But if you want to try, you can. Your going to have to relieve the stabilizers, so the edge clears the hone's, then thin them back down, as originally.

Here's an example of what I mean.
Their the same, ones been reground, with heal and stabilizers thinned. Other is still in original condition. Its one that I never would have touched, in my restoration beginning's, till I'd gained some more skills.

I do believe there's info in the library on this subject, too. But you need that clearance, so it'll hone properly. Period..!!
Other than that, the hone wear looks fairly even.



Another in progress of thinning. After chip removal.





How it should look once done. Notice how the edge is now in front, and below the stabilizers

As Mike says it's pretty much past its use by date but you could practice on it.

If you do use a grinder to remove the stabiliser take care to not apply it to the wheel width ways you can tear chunks off the blade that way.
A slow speed belt or wet grinder would be best.
After you've done that the razor could have a new geometry depending on how much the stabiliser interfered but you'd learn a lot about restoring an edge & if it's even possible..

I don’t have access to a grinder and using one to reshape the stabilizer kind of scares me. I have been able to do that manually with a coarse diamond hone. I felt it was less dangerous for me and gave me greater control over the final results.

I use a pencil grinder in my dremmel. Very low speed and lite touch. Not for the beginner, IMHO. But that razor is a perfect candidate for a learning tool. Look at the geometry of good razors, use your marble to come up with ideas and outcome of doing things, beforehand. Like carpentry..measure twice, cut once. Cause ya cant put it back on once ya cut it off.

Dig in, keep us up on your progress. We can give pointers along the way.

But check the library on restorations n such. Get an idea of what's involved, first.

Again...measure twice, cut once. Plan your work, work your plan. Slow wins the race...unless your me.

I'm with Mike. Wrap it in many layers of duct tape and trash it. It's beyond worth the effort. 35 to 45 bucks on ebay will get you something worth working on. Sorry to be blunt.