Thread: Start to Finish Razor Restore !!!!

This is a thread that I have been wanting to do for awhile, but these things take time, and half the time when I go out to the shop I forget the camera....
This restore I finally got pics of just about the whole process so I figured I would do a complete restore in pictures....

This is a C.W.Dahlgren Eskilstuna Medalier Chicago 1893 the proof marks show 1886, 1888, 1881, 1878 the frameback is stamped Sanvik Bessamer Stal.....

The scales are Spalted Apple, the wedge is Brown Ebony....
Nickel Silver pins and SS washers...
This one has 15 coats of Satin Wipe on Poly for the finish...

Starting out the razor has a very small touch of rust and some patina, the scales are shot...



I have the wood cut at 3/16 thickness...



I put the wood together using rubber cement, make sure you leave the pattern that you want to show, to the outside...



I usually leave the wood in the vise and clamped up overnight


The razor all broken down, save everything !!!! you might need it....

While I am working on the scales the blade will be spinning along, I use the Turtle Wax Rubbing compound in with the walnut media (re-fresh this about every 4 months) after 48 hours I will check the blade and use 800 grit sandpaper to take off any remaining spots and let it spin some more After that it will go through the same thing with Corncob media and Turtle Wax Polishing compound.... Keep in mind this will not take off rust or pitting....



I use the old set of scales to get a rough idea of the size, and the curves I will need for the new scales



Note here, See how the scale is covering that veining on the wood ??? I want that to show in the new scales



You don't have to do this but it does give you a starting point...

I rough cut the scales out of the blanks...



Leaving plenty of wood to play with shapes that I might want....



These rough cuts then move to a bench sander, and I work out the shape I want for the scales,
freehand....



My rule on scale design in general.... Let the wood do the talking, fancy wood?? Simple scales.... Simple wood???? fancy scales......



These are still oversized, but they are getting close to what I want now...

Just sizing out the razor to the scales...



Deciding on the wedge...






Sizing out the wedge



The wedge marked for cuts

Good thread idea! I did that same razor. I left the frame matte, and mirror finished the blade. I thought it was really cool like that.

Scroll saws are a handy tool here



The wedge gets sized and sanded to the right angle...









The moment of truth !!!!! when you drill the pivot hole, you ARE committed, so make sure you do it right....
If you mess up here it's back to the beginning....