Thread: Making Oak Scales

Originally Posted by Milton Man

Lawrence, I think it has a nice chunky look to it - it's bold and makes a statement. I'd say for a first attempt, you did great! Keep at it, and keep experimenting - different looks and pushing the envelope are definitely welcome.

Thanks A lot Mark!

Originally Posted by Milton Man

Two quick questions though -1) are the other side of the screws bolted or are they biting just into the wood;

I didn't even realize I didn't take pictures of the other side. They have nuts on that are the same size as the heads. they also have the beveled washer. I cut the bolt, then ground it flush to the nut. I'm at school right now, I'll take a picture of the other side tomorrow.

Originally Posted by Milton Man

2) did you have to significantly enlarge the pivot hole in the razor to get the screw to fit through?

No. The Brass washers that go INSIDE on the blade end needed to be drilled out. so did the spacer. but the screws actually fit through the original blade hole. mind you though, it was a VERY tight fit, I actually had to get a screw driver and turn the screw in.

I didn't like the idea of the EXTREMELY tight fitting screw, so I took it out, and drilled maybe 1/32"nd of an inch bigger hole. it is still tight, but I like it that way. opening the razor feels firm. and the blade stays where ever you put it. I was really afraid of ending up with a floppy razor.

-Lawrence


EDIT:

You can see the nuts peeking out on this picture.