Results 1 to 10 of 17
Thread: Sources for replacement scales?
LinkBack URL
About LinkBacksHybrid View
-
01-28-2010, 06:31 PM #1Senior Member
- Join Date
- Jan 2010
- Location
- Tampa by way of MIAMI!!!!
- Posts
- 105
Thanked: 15
I think I found what you meant.... GOOGLE is my friend. lol
Folding Knife Parts : US Knife Makers!, Operated by a knifemaker for knifemakers!
Are roller bearings a little excessive? lol
-
01-28-2010, 07:08 PM #2Senior Member
- Join Date
- Aug 2009
- Location
- Butte, Montana
- Posts
- 184
Thanked: 60
That's right. I got the little 1/8" pivot sets. Tracy Mickley is a good guy to deal with.
Originally Posted by firefighter
-
01-28-2010, 08:15 PM #3At this point in time...
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 26,986
- Blog Entries
- 1
Thanked: 13234
Just a little hint here guys,,,
Most razors have tang holes that are 5/64 in size some are punched holes or worn holes that will fit a 1/8 size pin/screw but many of those are not round... Be prepared to do some modification of tang holes as soon as you go above 1/16 pins/screws
-
The Following 2 Users Say Thank You to gssixgun For This Useful Post:
firefighter (01-28-2010), PDobson (01-28-2010)
-
01-28-2010, 08:47 PM #4Senior Member
- Join Date
- Aug 2009
- Location
- Butte, Montana
- Posts
- 184
Thanked: 60
Good point. The hole on my Genco wasn't even close to round. It was small too. A straight-flute carbide bit is your friend in these situations. Originally Posted by gssixgun
-
The Following User Says Thank You to PDobson For This Useful Post:
firefighter (01-28-2010)
Reply With Quote