Results 11 to 15 of 15
6LikesThread: My first scale de-pin
LinkBack URL
About LinkBacks-
06-08-2012, 09:58 AM #11The Great & Powerful Oz
- Join Date
- May 2008
- Location
- Bodalla, NSW
- Posts
- 15,626
Thanked: 3749
As above ~ it's all about slow & steady, especially with ivory.
-
06-08-2012, 10:14 AM #12Obsessive compulsive
- Join Date
- Feb 2010
- Location
- New Zealand
- Posts
- 1,315
Thanked: 323
Drill presses are great IF you have a centre bit to start the hole. Well done though I bashed a few to oblivion before I got the hang of unpinning.
-
06-08-2012, 10:57 AM #13Member
- Join Date
- May 2012
- Location
- New Zealand
- Posts
- 78
Thanked: 2
I just tried the drill press method, worked out pretty good as you can see I filed the pin first to get it straight so it was easier to centre the drill bit
-
06-08-2012, 11:22 AM #14Member
- Join Date
- May 2012
- Location
- New Zealand
- Posts
- 78
Thanked: 2
The blades are now being treated by the Electrolytic process
-
06-08-2012, 12:00 PM #15Senior Member
- Join Date
- May 2011
- Location
- Redbank, Queensland, Australia
- Posts
- 1,639
Thanked: 291
I use these to drill out the pins in my drill press - they are stiffer and less prone to 'wandering' than standard bits.
2.0MM-5PCE Professional A-Type HSS Center Drill Set (Free Postage) | eBay
You still have to be careful though
-
The Following User Says Thank You to Havachat45 For This Useful Post:
mycroftar (06-10-2012)
Reply With Quote
