Thread: Restoring a B.J. Eyre & Co Challenge, looking for some advice

So here is an update. I went to Home Depot and bought a filing kit and was able to file the pins down. I dissasembled the razor and the first thing I noticed was how sticky the spacer was. It looked like it had sludge on it. The sludge was also around the pin hole of the razor.


I put some Mothers near the tail and pin hole and started buffing away. I knew I would need to get some Mothers in the pin hole as well to get out any rusted metal. I found a leaf on the ground and started using the bottom of the stem to get the Mothers in the pin hole. Within a minute or so, I was literally scooping metal out of the hole with the leaf. The metal was so corroded it turned into the sludge I mentioned earlier. The crater that is in the handle is a little more than 1/8 of an inch, though the actual hole itself is a little smaller. Before I continue putting anymore work into it, I was curious if this would be a huge problem. I don't have many tools at my disposal. I haven't made scales before, nor have I tried repinning a razor. I imagine if I were to finish the restoration (which I would like to do), I would need to make the hole uniform so I could have a pin fit snuggly in there. Would I need to get a round file and slowly make the inner hole match the size of the crater?

Anyway, after an hour of Mothers and elbow grease/butter alternative, most of the active rust has come off. There is still some near the top end of the blade, so I think I'll need to grab the sandpaper. It isn't nearly as bad as I was expecting it to be, so I'll start on the higher end and work my way down if need be. Thank you everyone who has contributed thus far, your help is very appreciated.



This is before any Mothers