Results 1 to 10 of 32
Thread: Barber says no!
Threaded View
-
06-19-2009, 01:44 PM #19
I see where Glen is going here. With many tools you hone one side until you get a burr, then flip and remove the burr. With such a "large" thin piece at the edge of the blade I can see it rolling up on itself.
With a straight though you should never have a "burr" as I explained it above. We have all for the most parts seen many different magnified pictures of straight and I have never seen anything resembling a burr rolled up on itself. All straight razor edges should look like triangle when cross sectioned.
If you are honing a razor and seeing this type of burr you are probably using too much pressure.
-
The Following User Says Thank You to JCitron For This Useful Post:
gssixgun (06-19-2009)