Originally Posted by
Bayamontate
I finished the CMon, the following is the procedure I used:
I lapped the 4K with a DMT 325, cleaned the hone off and raised some slurry with the same DMT.
I did 40 lite pressure circles followed 10 X strokes and repeated 5 times until I could shave arm hair at skin level. I rinsed the 4K, raised very thin slurry and did 10 X strokes, then repeated this with water only.
I lapped the 8K with the DMT 325, cleaned the hone off and raised some slurry with the same DMT.
I did 40 circles less pressure followed by 10 X strokes 4 times, after this I was able to cut hair a 8th inch above skin level. I rinsed the 8K, did 20 X strokes on water only.
I re-lapped the 8K side with the DMT, followed by 2000 grit sandpaper, then 4000. The surface of the 8K became less matted.
I did 30 X strokes with no pressure, 50 laps on weaved cotton, and 100 on English Bridle. I got to HHT 4.