Originally Posted by
MikeT
I did some sanding of a blade face working through 1k grit.
BUT!
Something terrible happened. Somehow a piece of something hard, like a single grit from other sand paper or something I don't know, got in there.
Felt it grind on 2 strokes, stopped to look, the blade face was scored! S#!t!!!
It's already I thin grind blade so going over it again is not a great idea.
If I just hit the one spot then there would be a slight dip.
Really annoyed.
I need to take steps to keep my sandpaper separate and clean. Also a clean spot to lay the blade while working.
This ever happen to you guys?
Do you have methods/protocol for avoiding this while doing the fine grit stages of blade work?