There is 'some streaking' to it but the little dark streak is on the back scale and there is only some 'minor streaking' on the front scale..
This has been a frustrating project as it's for a friend who did some work for me in a 'barter trade'.
It's my very first attempt at using horn and it's a big razor.
I took my time and was very careful about the design and laid out and cut out with the two blanks taped together, the holes drilled and ready to be sanded every thing was looking great. I'd mocked everything up and as said once again all looked good.
Once rough sanded down to about .090 I started the final sanding up to 1K I then put the horn in some Neatsfoot Oil over night. When I'd drained the excess oil back into the container I found that the back scale had warped.#%^&^*()&^$*#%^@%^@%!
During the mock up before final sanding the blade sat about 1/8" 'Proud'/above the scales/just like I wanted. However after the warping the blade sits as you can see. :banghead:
On a positive note/it honed up nice with a very thin edge.
I do hope that the owner will like the work. :shrug: