Off center

[Cattleman02]

Upon dry fitting with out wedge blade is setting to the left un-centered in the scales.What would be the steps to get it centered? Do you need a pivot washer on both sides?

[Cattleman02]

here is my problem

[Cattleman02]

pivot

[Cattleman02]

And how do I rotate pictures lol

[rolodave]

Are the scales of even thickness
Are scales of even width
The hard part is getting the thickness the same from end to end and the same on each scale
I try to keep any unevenness to less than .003

[PaulFLUS]

Often the pin gets bent while pinning. Also the pin holes are not always perfectly round or straight as they were put through with a punch before there were drills. Pinning skills take a while to master. You might find that repinning will correct it. You might also consider a sleave if the pin hole is irregular.