As the OP, I'm chuckling a little bit since my intent was not to spark a debate on the merits of pins versus screws. But, I enjoy listening to anything razor and workshop related so as far as I'm concerned, this post can run whichever way it goes. It's all good.

I asked the original question since I'm cookin something up in my little noggin and it's related more toward screws than pins. This idea bouncing around up there begs the question, should one want to use some sort of screw system that would NOT be adjustable when finished, can some form of the loctite be used to ensure, once proper tension is applied to the screw, that such tension stays that way permanently?

It sounds like the answer is: Yes?

Chris L