Thread: Dremel Use

my 2 cents . If you do ever use one, make sure the wheel is rotating OFF the edge at ALL times. Make sure the edge is down flat, ( a piece of soft wood works) but I like the magnetic idea.

I would also add that doing it by hand has it's risks also. I have had a couple of slices on my finger tips from lack of attention. You won't hurt the blade though.

Thanks for the great advice all! I think I'll get some sand paper and do it by hand. See how that comes out and move on to the dremel from there if needed.

Best,

--Jim

Hey there

Working a razor blade with a Dremel isn't such a bad idea if, as suggested, you use proper PPE, and take it slow.
I still use a Dremel for certain aspects of my work. If I am working around a goldwash for example, I get the Dremel out.
I use the wire wheel to clean out the stamps. You can get a very good finish with the "finishing abrasive buffs" and "abrasive brushes".

Ultimately you can damage your razor if you don't take precautions. Have a cup of iced water around to keep the blade cool, have the attachments rotating away from the cutting edge. Dull all razors before you start work on a glass.

Good luck