Results 1 to 10 of 34
Thread: The daily chuckle
-
09-21-2017, 03:20 PM #1
- Join Date
- Mar 2012
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 17,311
Thanked: 3228The daily chuckle
Concentrated too much on making a clean joint using 5 minute epoxy and not on something else.
Oh well another lesson learned the hard way.
Off to several freeze and heat cycles to see if I can break the bond. Gotta laugh when the hits just keep coming.
Bob
Life is a terminal illness in the end
-
-
09-21-2017, 03:52 PM #2
I'm a little slow this morning -- what's the problem? I see epoxy in the pivot hole but wouldn't you just drill through that?
-
09-21-2017, 03:58 PM #3
It’s upside-down. Damn, that’s something I could certainly see myself doing even if properly caffeinated.
--Mark
-
09-21-2017, 04:08 PM #4
-
09-21-2017, 05:41 PM #5
- Join Date
- Mar 2012
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 17,311
Thanked: 3228Yea, a lesson in check 3 times then do. No, no epoxy in the pivot hole. That part worked out as planed considering I plugged the pivot hole with plasticine.
BobLife is a terminal illness in the end
-
09-21-2017, 05:48 PM #6
Oh boy, sometimes everyday is a Monday
Sorry to see thatLook sharp and smell nice for the ladies.~~~Benz
Imperfection is beauty, madness is genius and it's better to be absolutely ridiculous than absolutely boring ― Marilyn Monroe
-
09-21-2017, 05:50 PM #7
remember caffeine before working on project, scotch afterwards
-
09-21-2017, 06:08 PM #8
- Join Date
- Mar 2012
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 17,311
Thanked: 3228
-
09-21-2017, 06:09 PM #9
you're right I'm sure
Look sharp and smell nice for the ladies.~~~Benz
Imperfection is beauty, madness is genius and it's better to be absolutely ridiculous than absolutely boring ― Marilyn Monroe
-
09-21-2017, 11:38 PM #10
took me a minute too. It does look kind of like a Kamisori though.