Printable View
I started on the last two razors, belonging to MrZ.
Blades only need a bit of cleaning at the pivots, its the scales that need attention.
Attachment 295982
Giving the scales for his Reynolds another day of drying, and will be pinned later thus evening
I am about to have three awesome razors! I would have tried to use CA glue to fill those bug bites, but I really liked those razors to much to mess them up, so off to Akron for a champion restorer to do it right. I will keep trying on junk blades, but Outback is the man. I cant wait to see them.
Attachment 296039
Attachment 296040
Here are the scales from the Tally Ho that I'm working on.
I did a bit of sanding with 1500 grit wet/dry sandpaper, and they are cleaning up. However, the blacker of the halves has some gouges in it as seen in the 2nd pic. Should I just do my best to smooth that out with some lower grit paper and then work my way up again to the higher grit paper? I've got up to 3000 grit if needed.
Also, I think I've heard about soaking in oil at some point?
Yup. Try some scotchbrite. I love that on horn scales. Fine steel-wool. Blends things nicely, for me.
Depends on the finish you want. I typically go no lower than 400 grt., then 600, 0000 steel wool, for a grainy matte look. Or I'll go as high as 1500grt., and buff for a polished finish.
Attachment 296045
Attachment 296046
Made the repairs on MrZ's scales tonite, and was about to pin up the Reynolds when I remembered I still needed to make a wedge for it. :banghead: DAMMIT.!!
Im off work tomorrow, so I'll have it ready for an evening shave, after I hone it that is..:gaah:
Attachment 296047
Attachment 296048
Attachment 296049
Attachment 296050
Attachment 296051
There is so much to learn from all of you guys. The quality of work that goes on around here is amazing.
This is true!Quote:
Originally Posted by MrZ
Finally..!!
I got the wedge made and fitted to the scales using mock up screws, and the help of a piece of paint stick to replicate the tang. Once the mass of the wedge has been removed from around the scales, I replace the paint stick with the actual blade, so I can shift the scales and center the blade without having to use shims on the tang, then snug it all down and do the final fitting on the wedge.
Attachment 296060
Attachment 296061
Then a quick dismantle, and pinned up with some of Austin's collars, and brass rod.
Attachment 296062
Attachment 296063
Attachment 296064
Attachment 296065
Ready for the hones..Attachment 296066
Attachment 296135
I noticed a drilling error on this one. I was thinking that filling this in with epoxy might be the trick. Any better approach to this?
Also, if I buff these, is there a preferred buffing compound for this?
I have some pinning supplies on the way, so I'll be wrapping up this project soon.
