Piddling with the box here. Looks silly now, but I can see the outcome. (I think!)
Plywood drilled with the razors in order for some of Babur's stainless pins which I don't use. Have a reft of them! ;)
Attachment 231542
The pins were located with one sporting a covering of teeny black heat shrink tubing (shown below).
They all stay put with a tiny pit of movement without the tubing on the pins. Of course, they will need to stay in order!
Attachment 231543
The plan is to size the heat shrink so the pins will be tapped thru the plywood, cut off underneath, and the heads will be right at the level of the scales after a thin layer of foam and then fabric is applied. The razor can be retrieved by simply pushing down on the tang to raise it. If it works out, the whole thing will be glued down in the bottom of the box, some padding and fabric in the top to give a very light squeeze. Having a tough time finding some silver hinges and latch, but that's later. If it does not work out, nothing but some time lost!