Nice, looks like there's a toe chip or is that the pic?
Should clean up very well though. Nice grind.
Cheers
Printable View
Nice, looks like there's a toe chip or is that the pic?
Should clean up very well though. Nice grind.
Cheers
Its not a stub tail. It is a true convex wedge.:D Only has Johnson on it. Looks like someone tried to grind it flat. I was going to try and make it a frameback.
No chips. A little wear on the toe, heavy hone. But not to bad.
Started with 400 w/d paper.Attachment 209040
Attachment 209041
Thanks gents.
I'm going to use this one as both test subject and sacrificial horn stock and try to save the originals.
Attachment 209042Attachment 209043Attachment 209044Attachment 209045
The one end is missing some, but I have the other for profile. There is also a chunk out of the side of one but it will be a fun experiment if nothing else. I think the wedge is done though and will make a new one out of brass stock.
If the scale restore isn't to my liking new ones in honey blond horn will be on deck I think.
Nothing acrylic or kirrinite-ish on this old soldier.
Cheers.
Enjoying this thread gents. Can't wait to see that WB finished.
So I am getting happy with my stabilizers. Seems they keep on multiplying! :D
Figure I will get my aluminum pop rivet blade bushing in now so as working on the tang a bit, I can also smooth out the grinder's slips there!
I use an old, trashed Dremel pointed reamer with a 1/8 shaft. A drop of oil and it goes right through these odd-shaped holes. I do use a slow turning drill press and take my time.
Pop my rivet in, knock out the mandrel with a 1/16 punch;
Attachment 209056Attachment 209057Attachment 209058
Then, dremel drum the head down so thin, I can pick it off with a pocketknife. Grind the other side to just proud of the tang;
Attachment 209059
I then take it to my peening anvil and tap it down, squishing it into the remains of the odd-shaped hole, down to the tang.
Attachment 209060Attachment 209061
I will run a 5/64 bit thru and saw back and forth to make certain the pin is comfortable where the scales dictate.
Too tight of a pivot bushing can cause seizing and fitment issues, IMO.
For the record, I do not think this is necessary for most old razors. On this one, my shortened FBU scales are going to make things pretty darn tight, so I don't want it walking forward toward the wedge. This bushing will keep it from that.