Thread: What Do You Have In The Mail Right Now?

Originally Posted by PaulFLUS

You guys would probably laugh at me. I used regular charcoal in a charcoal lighting chimney stoked by an air mattress inflator. I used a pair of channel locks to pull it out to do my magnet test then after non-magnetic put it back in for, oh...about yay long; probably long enough for me to hum the final Jeopardy tune a couple of times in my head. Then I quenched it in mineral oil, wiped it off with a paper towel and washed the residual oil off with lava soap in my sink. Then I did the tempering in my toaster oven but hey, I did have an oven thermometer in there. What?!? I'm not a total half ass...

Like this? ♫♬Dum dum dum, dada dum dum dum, dum dum dum dum DUMMMM! da dada dada dum dum dum, dada dum dum dum, DUM--- da dada dah, dum! dum! dum! (BOM! BOM!)♫♬Hey, works for me. I made a few barbecue razors so I'm not laughing.

Seemed like a good deal.

Slowly converting my brother in law. Been using a Gillette slim for a couple years now so time to up to soap and brush. So TOBS sandalwood cream and a AP shave co 2rmm tuxedo shaving brush for him amd grabbed same brush gor me while at it.

For me I have captain crush grips, Amouage Jubilation XXV, some fragrance decants and 5ml glass atomisers en route.

Lots os fragrance decants. 15 from Xerjoff and 2 from Nishane

It’s here!

Got a nice score on an S.R. Droescher Swaty 3 line barber hone on the bay today, ETA 18th, comes in the original box which looks mint, hone has a little bit of wear but all the edges appear pristine and chip free which is always a good sign imo. Also have the 3 slates from Vermont finally on the way (a green, purple and gray all with slurry stones) which I will post up to the Vermont Slate thread, should be here next week. Bagged a lot of nice hones lately for absolute peanuts.

(Yes I know the Droescher Swaty is meant to be a bit naff, can just go into my collection if nothing else.)

....

Adjustable push rods?

Originally Posted by Grazor

Adjustable push rods?

Give that man a cigar!

Working on slowly collecting parts and tools needed to swap out the cam in my '13 Harley Heritage Softail. Going with a cam that has a ton of low end and midrange torque. I don't ride in the upper RPM levels.

I’ll stay out of guessing on all your new parts coming, but nice move