Results 5,241 to 5,250 of 20565
Thread: What are you working on?
-
10-22-2016, 02:50 AM #5241
TBH, I can see a sharp blade as tending to cut, gouge. It would seem that a worn edge or one which has been breadboarded would fill the bill. I suppose the tool used is also dependent upon the size of your project?
-
10-22-2016, 02:53 AM #5242
- Join Date
- Feb 2013
- Location
- Haida Gwaii, British Columbia, Canada
- Posts
- 14,439
Thanked: 4827They are used more vertical so the sharp edge or burr is not cutting but scraping. The opposite of shaving.
It's not what you know, it's who you take fishing!
-
-
10-22-2016, 02:54 AM #5243
- Join Date
- Aug 2011
- Location
- Upstate New York
- Posts
- 5,782
- Blog Entries
- 1
Thanked: 4249Luthier's use cabinet scrapers a lot on fine figured woods since a common hand plane would produce tear out.
-
-
10-22-2016, 03:03 AM #5244
Sounds like a fella could scrape more and sand less...
-
The Following User Says Thank You to sharptonn For This Useful Post:
Geezer (10-22-2016)
-
10-22-2016, 03:05 AM #5245
- Join Date
- Aug 2011
- Location
- Upstate New York
- Posts
- 5,782
- Blog Entries
- 1
Thanked: 4249There is no sanding needed after scraping it is a glass smooth finish.
-
10-22-2016, 03:06 AM #5246
- Join Date
- Feb 2013
- Location
- Haida Gwaii, British Columbia, Canada
- Posts
- 14,439
Thanked: 4827Scraping is a bit of a skill and people who are very good at it can get a fine finish on very tricky woods and never use sandpaper. If I was going to go that far my planes and chisels would need to be tuned and some probably simply are not good enough steel for the job. They were what was used before sandpaper though.
It's not what you know, it's who you take fishing!
-
-
10-22-2016, 03:07 AM #5247
The pores are more closed as opposed to sanding. Water will bead up on a burnished surface.
Rog
-
The Following User Says Thank You to Panama60 For This Useful Post:
sharptonn (10-22-2016)
-
10-22-2016, 03:12 AM #5248
-
10-22-2016, 03:16 AM #5249
-
10-22-2016, 03:19 AM #5250
I have a friend..(Tarkus) who roughs-out horn scales and sits and scrapes them into shape, adhered-together.
He hates to do it, but is quite good AT it!
http://straightrazorpalace.com/custo...2-general.htmlLast edited by sharptonn; 10-22-2016 at 03:23 AM.
-
The Following User Says Thank You to sharptonn For This Useful Post:
xiaotuzi (10-22-2016)