Printable View
The bone and horn slabs are a byproduct of agriculture and are a very sustainable industry, and produces such a beautiful end product, I think they are pretty perfect for our uses. I can't imagine what I will do with the G-10 and sheets of plastic I have lying around. I think I am pretty hooked on this product line, even if it is a little more expensive.
G10? Wot colors do you have? Green acrylic?
Faux tortoise...Faux pearl.
Like to have a bit of each!
I have trading fodder! :roflmao
G10 that like particle board furniture...
I don't know any more. I have not looked in that box for some time. I do know I bought some to make a box out of and some thinner material for scales. I don't like it. It is a pain to work with. I will email you when i get home from work.
How about a link to those washers? They look like some fine work. And you did them justice. Thanks for explaining.
There you go Nickel silver straight razor washers / collars/ pins , large and small | eBayQuote:
Originally Posted by Gasman
Got it. Thanks. Ordered the ni-silver and brass. Also some spacers. Now if i can hold off pinning my project razor for a month. Ha.
Nice job on the razor, Martin. It really came out a good one!! I'm a fan of the little bevel in washers too. A little time spent at the end with some very fine sandpaper and polish, it's all the little details that add up to the whole. Also, pins done this way feel nice in the hand, no rough edges. Great job!
+1 to all the above^^^^^^^
Fantastic peening work there Martin! And a great overall completed restore. Well done sir.
Shaun, not to pinch from Tom's box but I'd be interested in a lil swap o materialoski as well mate.
;)
Getting some initial time in on the cnc project and learning why this is not an easy 'off the shelf' artform, or tech form or whatever you want to call it. Making lots of scrap wood out of my scrap pieces, so I have kindling covered for the next few months. But I am seeing constants emerge that I am learning from.
Almost ready to tackle some Otto font I think. :tu
Cheers gents.
Here is a strange one...
Old Torrey. One of the early examples made by Turner, possibly piecework from Connecticut prior to his joining forces with Torrey.
Pinned it up collarless a long while back. It would close center, but as you opened it backwards and then closed again, it might hit the front scale unless you pushed the blade forward. Could not figure it out and, what with collarless peens, did not want to experiment further. It went to live with a friend for a while...
Told him to watch it as he closed it.
Fast forward a few years and some horse-trading got it back into my hands.
Yup..Same issue still there.
Drilled the top-pin out and decided to SEE what was up.
Found that I remembered that the Sheffield-trained Mr. Turner made pinholes the old way.
Punched-in and oversized.
So I popped in an aluminum pop-rivet, peened the aluminum mandrel into the middle and set-up to drill a new 5/64 pin-hole at the rear of the spectrum.
Like this.
Attachment 260626
So as turning over the razor I see THIS!
Attachment 260627
WTF? I know I had the spine level and the tail supported...Drill went straight through?
Stuck a mandrel in...Level...Level...
Attachment 260628Attachment 260629
Oh well..Test fit had it closing perfectly no matter what!
Attachment 260630
So I have concluded the original hole was struck-in at a fairly good angle for some reason. Go figure!
I theorize that as the blade moved back on the pin during full opening and re-closing... The pin encountered a slanted surface...And it tilted the blade. That!
Got it all pinned back up. Right as rain.
Attachment 260631Attachment 260632
Always something new to see! ;)
