Thread: What are you working on?

Ok. Maybe just 1000 taps of the hammer. Ha.

For pins filling I use a set of EZE Lap small diamond files/plates, comes in medium, fine, superfine. Many uses for these little plates as well, you can easily reshape part of your razor, smooth out a burr etc. You could probably fix the geometry and stabilizer on a gold dollar with these as well but no guarantees on that since I have no experience with GD nor do I want any.

Originally Posted by outback

Looking at the spine, I would say its been somewhat reground, that should be bevel set before going any further.
It'll tell ya how wonky things really are.
Without tape will reveal the true spine wear.

I assume its a wedge.?

Yeah its a wedge, Ill try that before going any further with it

Thanks Martin. Ill look into those. They look a bit wide for file use to me but with some care i guess it can be done.

About 6 months ago I noticed some fresh rust on this Merx razor. Removed from gen pop and quarantined i just opened the container for the first time since then. The blade had a nice coating of Ren wax on it.. did not matter. Definitely off gassing. No heavy odor when I opened the container they were in though.



Faux ivory scales?



I have a few little fix up razor jobs im gonna get done today. First thing on the list is get this blade out of these scales.

Yup, make a pattern, before you toss them…

I'm saving the scales.. for science.

Sent from my SCH-I545 using Tapatalk

Originally Posted by MW76

I'm saving the scales.. for science.

Sent from my SCH-I545 using Tapatalk

Way ahead of ya, Matt.
Put the Fishin hook in there mid last year, its showing first stages of rust at this point, with light pitting.

Originally Posted by Martin103

For pins filling I use a set of EZE Lap small diamond files/plates, comes in medium, fine, superfine. Many uses for these little plates as well, you can easily reshape part of your razor, smooth out a burr etc. You could probably fix the geometry and stabilizer on a gold dollar with these as well but no guarantees on that since I have no experience with GD nor do I want any.

A Diamond nail file might be a way to go too.

Originally Posted by Gasman

No sharp points or edges now Roy. Your directions helped a lot in that mater. It takes three times as long to pin now and 2000 to 3000 taps (guessing) but the outcome on the pins is better now. Smooth to the touch. Thanks for the details on getting a better pin job. I'll get faster with practice. And i could use some better files. These cheep H.F. files suck.
BTW, where do you guys buy quality mini sized files?

The etching on that scale looks great and so does that brush. Nice work guys.

Many hobby stores have small files for miniatures cast in pewter.

Excel Hobby Blades - 12 Mini Files, 4"